E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC

60-Amp Pro Switch-Mode BEC Brushless ESC

Overview
The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Key Features

    Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
    5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
    Stronger BEC for support of most 3-axis stabilization systems
    Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended 
    input voltage
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Finned heat sinks
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V),
    5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    Programmable soft start for helis and airplanes
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
    Utilizes new smaller MOSFET technology to minimize weight
    Radio system power on/off switch
    Pre-wired connectors—E-flite® EC3™ connector on battery input and 3.5mm gold bullet
    connectors on motor output leads

Specifications
Amperage:  40-60
Brake:  Yes - Programmable
Cells w/BEC:  3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Continuous Maximum Current:  50 - 75A
Height:  0.61 in (15.5mm)
Input Connector Types:  EC3
Input Voltage:  10.8V - 22.2V
Length:  2.85 in (73.0mm)
Momentary Peak Current:  15 sec @ 75A with proper cooling air flow
Output Connector Types:  13 AWG with 3.5mm female gold bullet connectors
Type:  Brushless
Weight:  2.65 oz (75.0 g)
Width:  1.30 in (33.0mm)
Wire Gauge:  13AWG